Page 76 - Router Catalogue 2021

WEALDEN TOOL
TCT ROUTER BITS Quality products - quality service
COM PAN Y

PANEL RAISING

Two wing cutters in 1/2" shank size to produce traditional raised and fielded
panels. The T1920½ and T1922½ series produce a maximum cut width of
30.5mm and, if used freehand, must be used either with a roller follower or
guide fence. The T1930½, T1932½ & T1933½ series cutters produce a
larger panel raise of 42mm. They can be used in stationary machines and
may also be used in the larger variable speed portable machines. Please ask T1920½ &
for advice if in doubt about the suitability of your machine. Cutter illustrations T1930½
are 70% full size.
A bearing guide kit is available to fit the larger sized cutters, however this will
NOT fit on the T1920½ or T1922½ cutters. When used with the bearing, the
tongue dimension “E” becomes 6mm. This kit should be ordered separately.
N.B. THE T1930½, T1932½ & T1933½ ARE LARGE DIAMETER CUTTERS
– PLEASE ENSURE THEY WILL FIT THROUGH THE BASE OF YOUR
MACHINE AND THROUGH THE ROUTER TABLE. MAXIMUM SPEED FOR
THESE CUTTERS IS 15,000 rpm.

T1922½ &
T1932½

Guide bearing kit
(order separately)
NOT FOR T1920/T1922
Part No.
TB1900

T1933½

The full size illustrations above show the profiles produced by the cutters.
These are the maximum size that is produced. The quirk height can be
reduced as required and if a bearing kit is fitted the tongue dimension E
will become 6mm (T1930, T1932 & T1933 only).

Part No. A B C D E F G H

T1920 1/2 49mm 15mm 1/2 45mm 12mm 18.5mm - 5mm
T1922 1/2 49mm 15mm 1/2 45mm 12mm 18.5mm 6mm 8.5mm
T1930 1/2 64mm 15mm 1/2 45mm 20mm 22.0mm - 6mm
T1932 1/2 64mm 15mm 1/2 45mm 20mm 22.0mm 8mm 10.5mm
T1933 1/2 64mm 15mm 1/2 45mm 20mm 22.0mm 18mm 7.5mm

Orderline 01580 890500 74 Fax orders 01580 890222